The Triathlon Shop offers a full service, set up and maintenance facility at our flagship store in Bristol.
With Cytech level 3 qualified workshop staff we are confident that we can solve any problem you have with your bike.
A brief run down of our services can be found below, please feel free to email or call for any specific work or advice.
Bronze: £40 Ideal for bikes that are regularly maintained
Silver: £60 Perfect for bikes that are starting to show signs of needing some TLC
Gold: £90 Book this if your bike is struggling to stop or change gears correctly and could do with some love and attention
Platinum: £120 For bikes that need a complete overhaul to get them running sweetly again!
| Bronze | Silver | Gold | Platinum | |
| Check tension of bearings |
x |
x | x | x |
| Align gears and brakes | x | x | x | x |
| Minor wheel truing | x | x | x | x |
| Lubricate chain | x | x | x | x |
| Ensure all fixings are secure | x | x | x | x |
| Pressure tyres | x | x | x | x |
| Check and set up brakes | x | x | x | |
| Check and set up gears | x | x | x | |
| True wheels | x | x | x | |
| Remove, clean and refit transmission | x | x | x | |
| Overhaul or replacement of one bearing point | x | x | ||
| Clean frame and forks | x | x | ||
| Remove and replace brake or gear cables | x | x | ||
| Overhaul or replacement of all bearing points | x | |||
| Remove and replace cables and housing | x | |||
| Clean whole bike | x | |||
| Clean rim or disk brake surfaces | x |
Puncture repairs
Front - £7, Rear - £10, Both - £15
All require tube or tubes adding to cost.
The brake controlling the wheel on which the puncture is being repaired gets set up, as do the
rear gears.
Gear or brake setup - £7.50
Sets up of one gear or brake unit.
Replacement of inner cable - £10.00
One inner cable replaced. Includes setup of that part.
Cable not included.
Outer cable replacement - Dependant on time taken,
regarding internal cable routing and/or bar tape.
Usually £10-£15 plus cable.
Bearing service - £20
Strip and rebuild or replacement of one set of bearings
(headset, one hub, or BB). Two for £35 or all for four for £60.
Wheel truing - £7.50-£15.00
Getting your buckled wheel as straight as possible given
the condition the bike is presented in. If spokes need replacing,
the cost will be higher due to time taken removing tyre, tube etc,
plus cost of spokes.
Wheel building - £35.00
Spoke length calculation, lacing, tensioning and truing a wheel
of your specification. Parts not included.
Unspecified work
We charge £40/hour. If the work doesn't take an hour, we'll charge
you to the nearest 15minutes. Our minimum charge is £4.50 for
little tweaks which don't take very long.